Dynamic Advantage M&P M2.0 Magwell

Designed for modularity

New style will not have "Dynamic Advantage" on the side, but instead will have three lines just as the opposite side does. A small logo will be on the back near the set screw. Please see the last pictures for an accurate product. If you wish to obtain the old version, leave a message in the notes or email us. An additional two week lead time will apply.

This is THE most versatile magwell on the market, fitting more of an array of baseplates than any other magwell.

Fitting a variety of baseplates to open up the playing field for most users, this magwell was meant for modularity between users.

This is accomplished without a stepped internal shelf (like the Carver Tactical or Tyrant CNC) while retaining a true funnel shape into the magazine well.

Made from aluminum (sorry to my competition guys)

The lines being engraved on the sides are for a subconscious mental indication of mag angle during insertion. This allows a slightly quicker reload.

These are very tight-fitting on most frames. A rubber mallet may be required to fully seat the magwell onto the frame prior to securing with the supplied set screws.

The full-size polymer frame only compatible at the moment.

Tested so far:

Dynamic Advantage Tactical Competitor +5

Warne +5

Ed Brown +2

Floyd's +2

Floyd's +5

Taylor Freelance +0/+2

Taylor Freelance +5/6

TTI +5/6 & +2/3

Tyrant Designs +5

OEM Competitor mags

Not compatible with Carver or Springer +5/6 baseplates

If you are adding Cerakote, please allow an additional week for the coating process before shipment. The Cerakote process will fill in the laser engraving on the original anodized coating.

** Install notes - Remove takedown tool from the grip. Replace with the included pin. 

The front lip of this magwell (where your pinky would be placed) will slide onto the front portion of the frame; there is a slight protrusion of plastic that interfaces with the inside of the magwell. 

Once the front is aligned correctly, slowly press down on the rear of the magwell to mate with the frame. 

The rear may require some convincing to achieve a 0% gap between the frame and magwell. To assist in achieving this, use downward pressure to close this gap. A constant downward pressure may be required to insert the set screw into the rear of the magwell to secure the assembly.

We recommend to use a rubber mallet to strike the magwell until it fully seats if you are unable to provide enough pressure to achieve a 0% gap.

If you are unable to achieve the magwell interfacing with the frame to the above standard, the threaded set screw will not engage correctly and render the unit inoperable. Please use a small application of blue loctite on the set screw and allow to cure for 24 hours prior to using.