Breaching - Shocktube Deployment Cover

Shocktube Deployment Cover

Free sample of single prime deployment cover if you email us from your government email with a picture of your credentials. We'll send a cover that only works with a single prime (one shocktube) for display of deployment. The cover is equally as effective using it as single or dual primed.

Suggested with use in conjunction with K-Factor Breaching K-Clip for rapid deployment

We sought out on a quest to unfuck the deployment of shocktube and get off the X quicker.

Using a braided & protective cover, we were able to combine dual shocktube lines in a singular fashion. Running a dual primed charge during operations just became a whole lot safer!

These can be used with singular shocktube lines also for training or simple IDC's - whatever your heart desires.

These naturally deploy without any sort of tangling. Pull the shocktube bundle out and drop it while walking back to your MSD without fighting your lines.

No more electrical taping your lines together. No more hour long prepping of your dual primed firing device for operations. 

Slide your two lines of shocktube in, work the covering all the way down to the blasting cap, E-tape the covering to the shocktube on each end - and done.

This process takes about ten minutes for dual primed 30ft lines and makes for an extremely clean deployment every time. It adds very little bulk to the bundle as well.

Our Shocktube Deployment Cover being demonstrated after being stowed in this configuration for months. This is a dual primed unit shown.

Not only does this cover protect nonel, it allows a rapid deployment without any tangling. 

This adds minimal bulk to the firing system, takes less time to prep versus E-taping the entire length of the tubing, and ultimately allows the user to get off the X quicker and to their MSD.

For size reference, once completed, a dual primed 30ft system still fits inside of a Soileater Shocktube Retention setup. 

Its reusable nature allows the user to remove the tape from each end and pull the used tubing out. Constructed of high temperature materials and durable construction allow numerous shots to be pulled with a single cover. 

We offer this in 30 / 50 / 100ft lengths to fit MIL & LE requirements.

The line is reusable even when the charge is complete. We used high-temp coverings for the line which makes it reusable.

Remove the tape at each end, slide the deployment cover off the line. And it's ready for another install. 

Length of the covering is roughly 30-32ft, leaving enough to trim if desired.

50 foot and 100 foot sections now available.

Higher visibility red and green intertwined variants available. Lengths limited for certain colors.